Table of Contents
Advertisement
14. ALWAYS wear proper apparel. loose clothing or jewellery may
get caught in moving parts. wear protective hair covering to
contain long hair.
15. ALWAYS use recommended accessories. the use of improper
accessories could be hazardous.
16. ALWAYS remove plug from electrical outlet when adjusting,
changing parts, or working on the machine.
17. NEVER operate machine while under the influence of drugs, alcohol or any medication.
18. NEVER leave machine running unattended. turn power off. Do
not leave the machine until it comes to a complete stop.
19. NEVER force the machine. it will do a better and safer job at
the rate for which it was designed.
20. NEVER use power tools in damp or wet locations or expose
them to rain. Keep your work area well illuminated. do not use
in explosive atmosphere (around paint, flammable liquids etc.).
Avoid dangerous environment.
Additional Precautions For Power Tools
1.
ALWAYS wear ear protectors/defenders as the noise level of this machine can exceed
85dB (A).
2.
ALWAYS use the appropriate sanding pads for the work being done. Replacement
pads are available from your CLARKE dealer (see parts list for details).
3.
ALWAYS keep the mains cable well away from the machine and ensure an adequate
electrical supply is close at hand so that the operation is not restricted by the length of
the cable.
4.
ALWAYS switch the machine OFF immediately the task is completed.
5.
NEVER allow the ventilation slots in the machine to become blocked.
6.
DO NOT use the machine if the electric cable, plug or motor is in poor condition.
7.
DONOT exert pressure on the sander to stop quickly, allow it to stop normally.
Additionally, please keep these instructions in a safe place for future reference.
DUST EXTRACTION
The sander is provided with a dust extraction facility, where a vacuum extractor, or dust
bag (not supplied), may be connected to the outlet at the rear of the machine. Please
note however, that this does not preclude the user from wearing a face mask to prevent
the inhalation of dust particles.
It is an EEC requirement that a dust extraction facility be provided on power tools, however,
due to the nature of the tool, some of the dust produced will be forced into the surrounding
atmosphere, and will not be collected.
-4-
Advertisement
Table of Contents
