Installing The Backstop; Attaching A Dust Collection Hose - Clarke CS4-6E Operation & Maintenance Instructions Manual

INSTALLING THE BACKSTOP

1. Position the backstop against the
frame so that the slot aligns with
threaded hole in the frame.
2. Secure the backstop to the frame
with 2 x socket head screws and
washers as shown.
• Do not overtighten.
• The gap between the sanding
belt and the backstop should
be no more than 2 mm.

ATTACHING A DUST COLLECTION HOSE

This sander is equipped with a 2½" (60
mm) diameter dust port that can be
connected to a vacuum or dust-
collection system.
1. Place a 2½" ID diameter hose over
the dust port.
Secure the hose in place with a hose
clamp.
8