Table of Contents
Advertisement
22/56
Transport and storage
Bosch Rexroth AG, DB(W)...5X/...E, RE25802-B/09.19
6.1.1 Transport using lifting gear
In transport, consider the following aspects:
• Properties of the load (e. g. weight, center of gravity, mounting and
attachment points).
• Type of attachment or pick-up of the load
• Ensure that the lifting gear's lifting capacity is sufficient in order to transport the
safety valve in a risk-free manner.
• Use textile attachment devices according to DIN EN 1492-2.
More information regarding the transport is available from Bosch Rexroth.
More information regarding the transport using chain hoists is also available in
the data sheet 07600-B, chapter 6 "Transport and storage".
Notify your responsible sales contact person transport damage within one week.
The addresses of the sales subsidiaries can be found on the Internet at:
http:/www.boschrexroth.com/adressen
6.2 Storing the safety valve
Safety valves are delivered in an unobjectionable state.
For transportation and storage of the product, always observe the environmental
conditions specified in "Data sheet 25802". Improper storage may damage the
safety valve.
Safety valves can be stored for up to 12 months under the following conditions:
Ensure a storage temperature range of +5...+40 °C.
f
The relative air humidity may not exceed 65%.
f
The storage rooms must provide 100% UV protection.
f
No ozone formation may occur near the storage facility.
f
The storage facilities must be free from etching substances and gases.
f
Do not store the safety valve outdoors but in a well-ventilated room.
f
Protect the safety valve against humidity, particularly ground humidity. Store the
f
safety valve on a shelf or on a pallet.
Store the safety valve protected against impacts and sliding and do not stack it.
f
Safety valves may be very heavy. In this connection observe the admissible load-
f
bearing capacities of your storage system.
Store the safety valve in the original packaging or comparable packaging in order
f
to protect it from dust and dirt.
All ports at the safety valve must be closed with closing elements.
f
After opening the transport packaging, it must be closed properly again for the
f
storage. Use the original packaging for storage
Advertisement
Table of Contents
