To Connect The Gas Supply - Fisher & Paykel OR90LDBGFX3 Installation Instructions Manual

To Connect the Gas Supply:

1. Fit the 1/2" BSP (female) connector (supplied with the cooker in a separate kit) to the gas inlet at the rear of the
cooker interposing the gasket. Check the correct positioning of the connector as shown and always use two
suitable spanners (Fig 11b).
2. Connect the gas supply to the right or left gas inlet at the rear of the cooker. The pipe is not to cross the cooker.
3. Close the unused end inlet pipe with a plug, interposing the gasket (Figs. 11a - 11b).
4. To avoid damage to the appliance gas rail inlet pipe tighten the fittings using two suitable spanners (Fig. 11b).
5. Using a suitable leak detection fluid solution (e.g. Rocol) check each gas connection one at a time by brushing
the solution over the connection. The presence of bubbles will indicate a leak. If there is a leak, tighten the
fitting and then recheck for leaks.
Do not use a naked flame to test for leaks.
Fig. 11a Gas Supply Intake
https://producthelp.fisherpaykel.com/eu/Cook/Freestanding_Cookers/Dual_Fuel/OR90LDBGFX3/User_Guide_OR90LDBGFX...
Fig. 11b Connecting the gas
Updated: Fri, 10 Apr 2020 07:18:41 GMT
Powered by
9