K-Line TRASHCUTTER 2740T Operators Safety Manual page 24

S A F E T Y
BEWARE OF CRUSHING HAZARD WHEN ENGAGING & DISENGAGING
SAFETY LOCKS & IN THE OPERATION OF THE WING FOLDING MECHANISM
• Beware of pinch points in wing lift area when
securing or releasing safety locks.
• Never stand within radius of wings when in raised
position, or folding and unfolding.
UPTHRUST FORCE ON DRAWBAR
TO UNFOLD MACHINE
‫ ـ‬Tractor weight must equal machine weight
‫ ـ‬Drawbar pin must be firmly secured
• Un-lock hydraulic tap on tilt ramhoses. Ensure
‫ـ‬
Safety chains attached correctly
hydraulic latching system is open.
Failure to comply will result in serious injury or death
• Reverse machine carefully until both wings are
fully open. *NB if both wings do not open fully
at the same time, lower tilt to lift transport angle
wheels partially to allow wings to fully open.
• 1. Close hydraulic latching system.
• 2. Lower wings to working position.
WARNING - WHEN OPERATING DO NOT
INADVERTENTLY RELEASE LATCHING SYSTEM OR
DAMAGE WILL OCCUR TO MACHINE.
TO FOLD MACHINE (FOR TRANSPORT)
1. Release hydraulic latching system.
2. lift tilt hydraulics to vertical position.
3. Drive slowly forward.
4. Fasten rear safety chain to both wings.
5. Observe stated speed limits when in transport.
DANGER: BEWARE OF UPTHRUST &
DOWN THRUST ON DRAWBAR DURING
OPERATION. (
Figure 19, pg 22)
• Tractor weight must be equal to machine weight.
• Drawbar pin must be securely fastened with
safety chains in place.
24
2740T TRASHCUTTER
new 2740 trashcutter op & safety manual.indd 24 new 2740 trashcutter op & safety manual.indd 24
Figure 24
Latch system closed for working
(figure 26)
(figure 25)
Figure 25
(figure 26)
Latch system released for transport
Figure 26
OPERATOR & SAFETY MANUAL
6/12/2019 7:07:01 PM 6/12/2019 7:07:01 PM