T Y R E S A F E T Y & P R E S S U R E S
SERVICING PROCEDURES
Figure 9
Figure 10
When optional flotation tyres are fitted
use tire pressures stated on the tire. If
no pressure stated use 50/55 PSI.
2740T TRASHCUTTER
new 2740 trashcutter op & safety manual.indd 17
new 2740 trashcutter op & safety manual.indd 17
•
Always cage tyres before seating beads.
•
Never exceed stated pressures when
seating beads.
•
Do not attempt to mount a tyre unless
you have the suitable equipment and
experienced personnel.
•
Inflating tyres can be dangerous.
Always stand to the side when inflating.
•
Failure to comply could result in serious
injury or death.
•
Load ratings of replacement tyres
should meet or exceed weight
requirements.
•
Correct pressure is 90PSI/620KPA
(Centre) 75PSI/517KPA (Wing).
•
Before mounting wheel to machine,
check all hub and rim contact surfaces
are undamaged and free of paint, dirt
and grease.
•
Lubricate wheel stubs with standard
viscosity oil.
•
Tension wheel nuts to 320ft/lbs
/433nm.
•
For field operation: Re-tension after
1st, 5th, then every 50 hrs of
operation.
•
For road travel re-tension first 3 miles
(5kms), 10 miles (15kms), and
thereafter at 25 miles (40kms) intervals.
OPERATOR & SAFETY MANUAL
17
6/12/2019 7:06:57 PM
6/12/2019 7:06:57 PM