RESEARCH CONCEPTS RC2000C Manual page 71

RC2000C Polar Tracking Antenna Controller Chapter 7 Troubleshooting/Alarm Codes 65
AZIM COUNT, ELEV COUNT
The internal position count has been corrupted. Manually find a satellite which has previously been
stored in non-volatile memory, and go into RE-SYNC mode to update positions. See Section 5.9.
AZIM SLOW SPEED, ELEV SLOW SPEED
The azimuth and elevation slow speed codes have been corrupted. The slow speed codes are entered
via the Azim and Elev Slow Speed CONFIG mode items. See Sections 5.10.4 and 3.5
AUTOPOL CONFIG DATA
Either the AutoPol Enable or AutoPol Vpol Level CONFIG mode items have been corrupted. See
sections 2.6, 3.8, and 5.10.1.
COMM PORT
This error (caused by an incorrect checksum) indicates that the value of at least one of the following
CONFIG mode items has been corrupted: Remote Mode Enable, Comm Port Baud Rate, or Comm Port
Address. Remote Mode Enable is the controlling item for this group of CONFIG mode items - it must be
enabled to allow access to the Comm Port Baud Rate and Comm Port Address CONFIG mode items.
See section 5.10.3.
GEO POSITION
The Geo Elevation Position CONFIG mode item has been corrupted. Please refer to sections 3.6 and
5.10.5.
POL OPTIONS
This error (caused by an incorrect checksum) indicates that the value of at least one of the following
CONFIG mode items has been corrupted: Rotating Feed Present, Rotating Feed CW Limit, Rotating
Feed CCW Limit, or Rotating Feed Jog Duration. The Rotating Feed Present item is the controlling item
for this group of CONFIG mode items - it must be set to YES to allow access to the other items. See
sections 5.10.6 and 3.3.
AZ/EL OPTIONS
This error (caused by an incorrect checksum) indicates that the value of at least one of the following
CONFIG mode items has been corrupted: Az/El Drive Options Enable, Az/El Fast Slow Threshold, Az/El
Retry Attempts, Az/El Fast Deadband, Az/El Slow Deadband, Azim Coast Threshold, Elev Max Position
Error, or Simultaneous Az/El Enable. The Az/El Drive Options Enable CONFIG mode item is the
controlling item for most members of this group of CONFIG mode items - it must be enabled to allow
access to the other items. See sections 5.10.2 and 5.10.7.
TIME/DATE
This alarm code indicates either the Time or Date is corrupt. The time and date are entered via CONFIG
mode. See section 5.10.8.
ANT/RCVR CONFIG
This error codes indicates that at least one of the following CONFIG mode items is corrupt: AGC Polarity
Flag, AGC C Band Threshold, AGC K/L Band Threshold, Antenna Latitude, Antenna Longitude, Ant Size,
Azim Constant, or Elev Constant. See sections 5.10.9 and 5.10.10.
TRACK CONFIG
This error code indicates that at least one of the following CONFIG mode items is corrupt: Max Track
Error, Search Enable, or Search Width. See section 5.10.11
Research Concepts, Inc. • 5420 Martindale Road • Shawnee, Kansas 66218-9680 • USA www.researchconcepts.com