Search Sub-Mode; Step Track Sub-Mode - RESEARCH CONCEPTS RC2000C Manual

RC2000C Polar Tracking Antenna Controller
5.4.1

SEARCH Sub-mode

The following conditions lead to activation of the SEARCH sub-mode:
1. TRACK mode is entered from AUTO mode and program track data is not available in the track table
for the current sidereal time,
2. the STEP TRACK sub-mode is active and the satellite transponder goes down,
3. or PROGRAM TRACK mode is active and the AGC inputs indicate that a satellite signal is not
present when the sidereal time advances to a value for which track data is not available in the track
table.
The behavior of the controller when the SEARCH sub-mode is active is determined by the state of the
Search Enable CONFIG mode item. If the search is disabled, when the SEARCH sub-mode activates,
the controller will prompt the user to manually align the antenna with the satellite (by using the jog keys)
and hit the ENTER key to transfer control to the STEP TRACK sub-mode. If the sidereal time advances
to a value for which track data is available in the track table, control will transfer to the PROGRAM
TRACK sub-mode.
If the Search Enable CONFIG mode item is enabled, the controller will perform a search for the satellite
using the Intelli-Search algorithm. When the search is performed, the controller will sweep the antenna in
a serpentine shaped pattern over the region where it has calculated the satellite will be found. The width
of the search box is controlled by the Search Width CONFIG mode item. If during the search a signal is
detected above the appropriate AGC threshold (either C or K/L) the antenna will return to the position
where the signal was detected and control will transfer to the STEP TRACK sub-mode. If the search is
unsuccessful, the controller will wait for Search Retry minutes before initiating another search. The
Search Retry parameter may be inspected and modified via the TRACK MENU - Modify menu.
Additional information concerning the Search sub-mode is available in section 4.2.3.
When the SEARCH sub-mode is active, the following messages will be displayed to the right of the
satellite name on the bottom row of the display.
SEARCH - A search is in progress. If a satellite is found, the STEP track sub-mode activates.
SEARCH IDLE - A search has been performed and a satellite was not found. The controller is waiting to
perform another search. The TRACK MENU function may be invoked to initiate another search, or to
change the Search Retry Interval. If the sidereal time advances to a value for which track table data is
available, the PROGRAM track sub-mode will activate.
5.4.2

STEP TRACK Sub-mode

When the STEP track sub-mode is active, the following actions can occur:
1. The antenna is periodically jogged in elevation and then azimuth to peak up the received signal
strength.
2. The controller compiles the track table.
3. Control will transfer to the PROGRAM track sub-mode if the sidereal time advances to a value for
which track table information is available.
4. If the signal strength indicates that the transponder has powered down, the controller will wait a short
while for the transponder to come back online before activating the SEARCH sub-mode.
5. The TRACK MENU system may be used to immediately trigger a peaking operation. See section
5.4.5 for a description of the TRACK MENU system. A more detailed description of the STEP track
algorithm is given in section 4.2.1.
When the STEP sub-mode is active, the following messages may be displayed:
Research Concepts, Inc. • 5420 Martindale Road • Shawnee, Kansas 66218-9680 • USA
Chapter 5 Modes Function Description 43
www.researchconcepts.com