Mitsubishi Electric FR-F800 Series Sample Screen Manual page 74

7.1.6 Inverter FR-F800-E
Inverter FR-F800-E Communication Settings
Operation mode selection
Communication startup mode selection
NET mode command source selection
PU mode command source selection
Ethernet communication network number
Ethernet communication station number
Ethernet function selection 1
Ethernet IP address 1
Ethernet IP address 2
Ethernet IP address 3
Ethernet IP address 4
Set the parameters above from the operation panel (FR-DU08) or FR Configurator2*1.
After the settings, the inverter will start with the NET operation mode when the power is on (reset). To
change parameters, etc. via GOT, switch the inverter to the NET operation mode.
Pressing the
*1: Only the simple mode parameter is displayed in default setting for FM type F800. To display simplemode
and extended parameters, set "0" to Pr.160 "User group read selection".
7.1.7 Screen Data
7.1.7.1 W-12010 Station Number Switching Window Screen
Apply the following settings to the switches in W-12010 Station Number Switching Window.
(1) Open the [Station No. Switching] under [Action List] and change the network No. to "2".
(2) Change the [Constant] of the [Lamp] function to network No. 2*1.
Item
key on the inverter body switches between the NET and PU operation modes.
Change to the Network No.2.
Parameter
Pr.79
Pr.340
Pr.550
Pr.551
Pr.1424
Pr.1425
Pr.1427
Pr.1434
Pr.1435
Pr.1436
Pr.1437
74/83
Set Value
0
10
5
2
2
1
5001
192
168
3
50
Change the Network No. to "2".
BCN-P5999-1067