Rear Panel - Fender Acoustic Junior Owner's Manual

REAR PANEL

L. POWER: Turns amplifier on and off.
M. IEC POWER INLET: IEC power cord connects to amplifier here. For Acoustic Junior Go
only, must connect to AC power to charge battery.
N. PHONES: 1/8" stereo headphone output automatically mutes speaker output.
O. AUX IN: 1/8" stereo input. Connect external audio player; use external device's volume
control to set accompaniment volume level.
P. BALANCED LINE OUTPUTS: Balanced line-level XLR output jacks for connection to
external sound reinforcement and recording devices. Changes to control panel settings
affect balanced line output signal (includes aux input and Bluetooth signals).
Q. MONO/STEREO: "Out" position is for normal left/right stereo effects output,
with channels one and two added together ("summed"). "In" position configures
both outputs to mono; use with MONO CONFIGURE button (S).
R. GROUND LIFT: "Out" position is for normal (grounded) operation. "In" position
can help alleviate unwanted line noise.
S. MONO CONFIGURE: When MONO/STEREO button (Q) is engaged, "Out"
position delivers channels one and two summed at both output jacks (CH2 +
CH1); useful for small-PA applications with minimal inputs. "In" position deliv-
ers separate outputs for channels one and two (CH2 or CH1); useful for sepa-
rating instrument/vocal mix for recording or performance.
T. USB PORT: The amp's control panel features a USB port for audio recording.
Using a micro USB cable (not included), connect a computer with recording
software to this port; the computer's audio control panel will display "Fender
Acoustic" as an audio recording device. For assistance with configuring and
using USB recording, visit the "Connected Amps" section at https://support.
fender.com.
Stereo USB output contains channels one and two summed (includes
aux input and Bluetooth signals).
U. RECOVER: For use by Fender service personnel only.
V. FIRMWARE UPDATE: If a firmware update is recommended,
instructions will be published at https://support.fender.com.
W. FOOTSWITCH: 1/4" input jack for connecting optional MGT-4
four-button footswitch; see "Footswitch" section.
3