67 MAX
Users Manual
Trigger Mode
Trigger mode saves battery power when the Product is stored in a toolbox or similar condition.
With Trigger mode On, if the trigger is pulled continuously, the Product turns off after
approximately 10 minutes. With Trigger mode Off the Product only turns off after the trigger is
released for 7 seconds. To turn Trigger mode on or off, push SEL until the display reads
tri9
, then push SET to toggle it On or Off.
Maintenance
Calibration and Verification
For calibration and verification, see the 67 MAX Calibration Manual located at Fluke's website
at www.fluke.com.
Change the Battery
Do not dispose of this Product or product battery as unsorted municipal waste.
To install or change the AA IEC LR06 battery, open the battery compartment and replace the
battery as shown in Figure 4.
Clean the Product
Use 70 % isopropyl alcohol on a sponge or soft cloth to clean the Product case. A swab may
be used to clean the IR lens. See Figure 4.
14