Advertisement
06
3
A sse m b ly o f se e sa w
A ttach seesaw to the shaft
Install 1 pcs
(fg. 06 + 07)
1. Connect seesaw w ith arm
holder B (fg. 06)
[A4] Arm holder B
2. A ttach arm holder B to the
shaft (fg. 07). Refer to the
assem bly of arm s (pag e 10
Lochprof l
Hole profle
and follow ing). Insert arm
w rench into arm holder B and
turn it by 90 degrees (fg. 03).
Note: T o m odify the angle of the
arm , release the fx ation frst
08-1
[S1] Shaft 391m m
4
A sse m b ly o f th e e le v a to r
1. Insert the 391m m shaft into
the gearbox (fg. 08-1)
2. Slide the elev ator (16 pcs)
onto the shaft (fg. 08-2).
Insert shaft into base (fg.
08-1). Please note the correct
direction of rotation
[G 1] Antrieb
[G 1] G earbox
3. Insert 3 further 391m m shafts
into the ex act pre-defned
positions on the gearbox (fg.
08-3)
4. Allow the 3 shafts to snap into
place (pic. 08-4). T ake care
that the elev ator rings are
properly located. See page 8
+ 9 for the proper locations of
the elev ator rings
5. Insert the 4 shafts into the
elev ator cov er (fg. 08-5).
T ake care that the shafts are
08-4
properly located
6. Now attach 3 rail stands [A 6]
to the elev ator ring (fg. 08-6)
Make sure conv ex red parts point
up and ev erything is correctly
seated.
m ount left hand side
[A3] Arm tube
Install 1 pcs
[E2] Elev ator ring
[E2] Elev ator ring
Assembly of base plate, arms & seesaw
07
Hole profle
m ount right hand side
Hole profle
Hole profle
08-2
[E1] Elev ator helix
Av oid that there is a gap betw een
gearbox and elev ator helix .
O therw ise the elev ator w ill not
operate properly . Please note the
correct direction of rotation
[E3] Elev ator cov er
08-5
[A 6] Rail stand
Note: W hen turning the arm w rench, m ake sure not to change
the right position of the arm
Adjust seesaw after assem by
08-3
[A 6] Rail stand
[A 6] Rail stand
08-6
[S1] Shaft 391m m
[A 6] Rail stand
7
Advertisement
