Advertisement
Assembly of rails
9
Rail track until junction. Install junction at the v ery end of the installation procedure
16
R a il a s s e m b ly s te p s
T his ball roller coaster prov ides 3
ex its (start) and 5 entries (end).
Please note fg. 16-22 and the
illustrations on page 2-4 during
assem bly
Install rail stands together w ith
the rails (fg. 26)
1. From elev ator ex it (start) to the
junction A entry (end): Install 2
x 61cm rails (fg. 16-1)
2. F rom the junction A ex it (start) to
the starter kit entry (end): Install
2 x 117cm rails (fg. 16-2)
From elev ator ex it (start) to the junction A entry (end)
Connect rails w ith the entry of
16-1
the starter kit and m ake fne
adjustm ents to slow dow n the
speed of the steel balls (balls w ill
rebound if too fast)
3. From starter kit ex it (start) to
the ball catcher (end): Install 2
x 58cm rails (fg. 16-3)
4. From pendulum tray for steel
balls (start) to elev ator entry
(end): Install 2 x 40cm rails
Install 2 x 61cm rails
(fg. 16-4)
17
5. From the junction A ex it (start)
to the low er elev ator entry
(end): Install 2 x 270cm rails
(fg. 17)
6a. From the upper elev ator ex it
18
(start) to behind the trav erse
loops: Install 2 x 507cm rails
(fg. 18). Caution: D o NO T cut
the rails here (section w ill be
continued as show n in fg. 19)
10
[Ex 7] Pendulum tray for steel balls
From the junction A ex it (start) to the starter kit entry (end)
16-2
Install 2 x 117cm rails
Do NO T cut the rails here (section w ill be continued as show n in fg. 19)
Release arm tube [A3] before m ounting the rails
From starter kit ex it (start) to the ball catcher (end)
16-3
Install 2 x 58cm rails
Junction A
From pendulum tray for steel balls (start) to elev ator entry (end)
16-4
Install 2 x 40cm rails
Junction A
Advertisement
