Advertisement
Assembly of rails
10
In sta lla tio n o f th e ra ils
A ttachm ent of rails to arm s and shafts (fg.
23 + 24)
A ttach rail to arm (fg. 23)
Rail joining (fg. 25)
A djust and connect the rails. Insert the rail
joining s [R2] into the holes at the center of
the rails (fg. 25)
Inform atons about rail stands (fg. 26)
T he distance betw een the arm s should be
betw een 8 to 10cm to ensure best stability .
W hen the distance is larg er , rail stands [A 6]
hav e to be installed
A ttach rail stands in steep sections and
elev ator entry /ex it points to ensure best
stability of the rails
Steep sections (fg. 27)
Install the arm s in an inclined position to
each other to create steep sections, so that
the steel balls can run sm oothly (fg. 27)
11
In sta lla tio n o f a lo o p
Ensurethe steel balls running sm oothly
28
(fg. 28)
T he diam eter of the outer loop should
hav e tw ice the diam eter of the inner loop
Im portant inform ation for the assem bly of
loops (fg. 29)
Rails hav e to form a circle that rem ains
in an upright position to ensure the steel
balls running sm oothly (fg. 29)
Installation of a loop (fg. 30)
W hen m ounting loops, the second loop
has to be sm aller than the frst loop to
ensure the steel balls running sm oothly
Installation of pendulum tray and junction
(fg. 31-1 + 31-2)
Insert rail stands into the junction (fg.
31-1)
Sim ply cut the rails to the correct length
31-1
(see enlarg ed picture on the right)
Insert rails into the pendulum tray (fg.
31-2)
[A 6] Rail stand
12
[R1] Rail
23
Insert rails into arm
25
26
Use rail stands like railw ay ties
27
Inner looping
Height
[P1] Junction
[A 6] Rail stand
24
[A 1] Arm
[R2] Rail joining
[R1] Rail
[R1] Rail
T he distance betw een the arm s should be betw een 8 to 10cm . W hen
the distance is larger, rail stands [A 6] hav e to be installed
Install the arm s in an inclined position
to each other to create steep sections
29
Cut here
30
Outer looping
Inner looping
Please refer to the illustration abov e for
diam eters of a quad loop (increase diam eter
w ith each additional loop)
31-2
[Ex 7] Pendulum tray for steel balls
-
Advertisement
