Dhcp Setup; Ip Pool Setup; System Dns Servers; Lan Tcp/Ip - ZyXEL Communications ZyXEL Prestige P-330W User Manual

4.3.1 DHCP Setup

DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC 2132) allows individual
clients to obtain TCP/IP configuration at start-up from a server. You can configure the P-
330W as a DHCP server or disable it. When configured as a server, the P-330W provides the
TCP/IP configuration for the clients. If DHCP service is disabled, you must have another
DHCP server on your LAN, or else the computer must be manually configured.

4.3.2 IP Pool Setup

The P-330W is pre-configured with a pool of 33 IP addresses starting from 192.168.10.33 to
192.168.10.65. This configuration leaves 32 IP addresses (excluding the P-330W itself) in the
lower range for other server computers, for instance, servers for mail, FTP, TFTP, web, etc.,
that you may have.

4.3.3 System DNS Servers

Refer to the IP Address and Subnet Mask section in the Setup Wizard chapter.

4.3.4 LAN TCP/IP

The P-330W has built-in DHCP server capability that assigns IP addresses and DNS servers to
systems that support DHCP client capability.

4.3.5 Factory LAN Defaults

The LAN parameters of the P-330W are preset in the factory with the following values:
• IP address of 192.168.10.1 with subnet mask of 255.255.255.0 (24 bits)
• DHCP server enabled with 33 client IP addresses starting from 192.168.10.33.
These parameters should work for the majority of installations. If your ISP gives you explicit
DNS server address(es), read the embedded web configurator help regarding what fields need
to be configured.

4.3.6 IP Address and Subnet Mask

Refer to the IP Address and Subnet Mask section in the Wizard Setup chapter for this
information.

4.3.7 Configuring IP

Click LAN to open the IP screen.
Chapter 4 System Screens
ZyXEL P-330W User's Guide
42