Verifying Settings; Figure 165 Red Hat 9.0: Dns Settings In Resolv.conf; Figure 166 Red Hat 9.0: Restart Ethernet Card; Figure 167 Red Hat 9.0: Checking Tcp/Ip Properties - ZyXEL Communications ZyXEL NBG334W User Manual

Appendix D Setting up Your Computer's IP Address
2 If you know your DNS server IP address(es), enter the DNS server information in the
resolv.conf
two DNS server IP addresses are specified.

Figure 165 Red Hat 9.0: DNS Settings in resolv.conf

nameserver 172.23.5.1
nameserver 172.23.5.2
3 After you edit and save the configuration files, you must restart the network card.
Enter
figure shows an example.

Figure 166 Red Hat 9.0: Restart Ethernet Card

[root@localhost init.d]# network restart
Shutting down interface eth0:
Shutting down loopback interface:
Setting network parameters:
Bringing up loopback interface:
Bringing up interface eth0:

25.6.1 Verifying Settings

Enter
ifconfig

Figure 167 Red Hat 9.0: Checking TCP/IP Properties

[root@localhost]# ifconfig
eth0
[root@localhost]#
264
file in the
/etc
in the
./network restart
in a terminal screen to check your TCP/IP properties.
Link encap:Ethernet
inet addr:172.23.19.129
UP BROADCAST RUNNING MULTICAST
RX packets:717 errors:0 dropped:0 overruns:0 frame:0
TX packets:13 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:730412 (713.2 Kb)
Interrupt:10 Base address:0x1000
directory. The following figure shows an example where
/etc/rc.d/init.d
[OK]
[OK]
[OK]
[OK]
[OK]
HWaddr 00:50:BA:72:5B:44
Bcast:172.23.19.255
MTU:1500
TX bytes:1570 (1.5 Kb)
directory. The following
Mask:255.255.255.0
Metric:1
NBG334W User's Guide