Dhcp Server Advanced Screen; Table 48 Network > Dhcp Server > General - ZyXEL Communications ZyXEL NBG334W User Manual

Chapter 10 DHCP
The following table describes the labels in this screen.
Table 48 Network > DHCP Server > General
LABEL
LAN DHCP Setup
Enable DHCP Server
IP Pool Starting
Address
Pool Size
Apply
Reset

10.3 DHCP Server Advanced Screen

This screen allows you to assign IP addresses on the LAN or Guest WLAN
page 117)
this screen to configure the DNS server information that the NBG334W sends to the DHCP
clients.
Every Ethernet device has a unique MAC (Media Access Control) address. The MAC address
is assigned at the factory and consists of six pairs of hexadecimal characters, for example,
00:A0:C5:00:00:02.
To change your NBG334W's static DHCP settings, click Network > DHCP Server >
Advanced. The following screen displays.
124
DESCRIPTION
Enable or Disable DHCP for LAN or Guest WLAN (See
117).
DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC 2132)
allows individual clients (computers) to obtain TCP/IP configuration at startup
from a server. Leave the Enable DHCP Server check box selected unless
your ISP instructs you to do otherwise. Clear it to disable the NBG334W
acting as a DHCP server. When configured as a server, the NBG334W
provides TCP/IP configuration for the clients. If not, DHCP service is disabled
and you must have another DHCP server on your LAN, or else the computers
must be manually configured. When set as a server, fill in the following four
fields.
This field specifies the first of the contiguous addresses in the IP address pool
for LAN or Guest WLAN.
This field specifies the size, or count of the IP address pool for LAN or Guest
WLAN.
Click Apply to save your changes back to the NBG334W.
Click Reset to begin configuring this screen afresh.
to specific individual computers based on their MAC addresses. You can also use
Chapter 9 on page
(See Chapter 9 on
NBG334W User's Guide