Table of Contents
Advertisement
Press the p key to select 'Yes' and start the measurement. The measured length is
displayed as below:
Hold the p and q keys (-/+) to display the length adjustment to achieve the actual
cable length and then press the 'PAIR&L' key to save the calibration factor and exit
the calibration function.
If the cable length being measured is too short (<5m), the following will be displayed
to prompt the user to use a longer cable for calibration. The user is also prompted
as to whether they want to continue calibrating or not.
Press the q key to select 'No' and exit the calibration function. Press the p key to
select 'Yes' and repeat the measurement.
If there is a fault on the cable being measured, a display typical to that below will be
shown to inform the user and to confirm whether or not to continue the calibration:
Press the q key to select 'No' and exit the calibration function. Press the p key to
select 'Yes' and repeat the measurement.
Note:
If the tester is restarted after it shuts off, the tester will recover the standard calibration factor of
Class UTP5 cable as setup during manufacture.
13
Advertisement
Table of Contents
