Coaxial Cable And Telephone Line Measurement Function - Triax 157011 Operating Manual

It will display an 'x' to indicate an open circuit if the length is less than 90% of the
other line pair length. In the example shown, the open circuit is located at around
89.7m from the tester. The open circuit line number could be rechecked using the
WIREMAP function.
Press the p key to return to the previous display or press the q key to show further
unpaired line number lengths. Press 'PAIR&L' to return to the main menu.

Coaxial cable and telephone line measurement function

After entering into the coaxial cable and telephone line, (Coax/Tel), measurement
function, the LAN Network Cable Tester will show a display typical to that shown
below:
It will display 'OPEN' if there are any open circuits or if the coaxial cable or
telephone line is not connected.
It will display 'SHORT' if there are any short circuits.
Press the p or q key to repeat the measurement or press the 'PAIR&L' key to
return to the main menu.
The far-end recogniser will sound a beep prompt if the cable connection is in a
normal condition.
Note:
For coaxial cable measurements, two BNC adaptor accessories are required. One is used to
connect the 'M' port RJ45 and the cable under test and the other adaptor is used to connect the
far-end matcher port 'R' and the cable under test.
For telephone line measurement, two RJ11 adaptors accessories are required. One is used to
connect 'M' port RJ45 and the cable under test and the other adaptor is used to connect the
far-end matcher port 'R' and the cable under test.
11