Silvercrest SV 125 C3 Operating Instructions Manual page 12

3) Lay the open end of the bag as far into the appliance so that the opening of
the bag is located centrally under the lower sealing ring 5. The bag should
be inserted no further than the rear limiters 6 and must lie between the front
limiters 7. If the bag lies over one or both of the two limiters 6/7, then the
bag cannot be correctly welded.
NOTE
The bag opening must lie fl at on the welding wire 4. Otherwise the weld-
►
ing does not work properly.
4) Close the appliance lid 1. The press seal q presses the bag onto the welding
wire 4, to create a smooth seam. Ensure that both corners of the appliance
lid 1 click closed. If necessary, press them down once again on the markings
and
5) Press the
process is completed, the control lamp r fl ashes briefl y and then goes out.
NOTE
► You can halt the sealing process at any time by pressing the
again. The control lamp r fl ashes and then goes out.
SV 125 C3
so that the appliance lid 1 clicks into place and locks shut.
button r. The control lamp r lights up. As soon as the sealing
button r
GB │ IE │ NI │ CY │ 9 ■