DoorKing 1838 Installation & Owner's Manual page 31

3.2.8 Elevator Control Feature
This new elevator feature authorizes floor access to the Floor Level identified in the Resident Screen in the software program AND
to the floor(s) level identified in the Security Level screen. If this feature is turned off, access will be granted only the floor
identified in the user's security level. This feature is available on Rev K boards or higher.
Factory setting = 1 (new elevator function is turned ON)
7 5
1. Press and enter your four-digit MASTER CODE
The OPTIONAL LCD display will read: NEW EL FUNC? 0=N 1=Y
1
2. Enter for YES (access is authorized to both the floor identified in the resident screen and to the floor(s) identified
in the user's security level) OR
screen), then press
0
3. Press together to end this programming sequence (beeeeeep).
3.2.9 Single or Multiple 1838s using ONE Phone Line
This program sequence sets the 1838 to operate as a single unit on ONE phone line, or to share the phone line with other units.
If multiple units are sharing the same phone line, then each one must be set as a "multiple system" and each must have a unique
master code.
Factory setting = Single System.
0 4
1. Press and enter your four-digit MASTER CODE
0
2. Press (beep) for a single system, OR
0
3. Press together to end this programming sequence (beeeeeep).
3.2.10 DKS Data over IP Phone Number or System ID Number
The following programming sequence is necessary ONLY when using DoorKing DKS Data over IP. After installing the Remote
Account Manager Software, Version 6.4.i, there is an option to use the DoorKing DKS Data over IP service type on the System
Information screen. When registering an entry system online with the DKS Data over IP requires either the 10-digit phone
number of the entry system or 10 digit ID number which DKS Data over IP will assign when registering.
or ID number MUST be programmed into the entry system to use the DKS Data over IP.
Visit http://www.doorking.com for more information.
Factory setting = No number in system
5 9
1. Press and enter your four-digit MASTER CODE
2. Enter the 10-digit phone number or ID number - assigned during registration, then press
0
3. Press TOGETHER to end this programming sequence (beeeeeep).
Notes: This programming sequence automatically turns DKS Data over IP ON (section 6.1.9).
To view programmed number in system see section 6.1.7. To check for problems see section 6.1.8.
1838-065 Issued 3-19
Version D
0
for NO (access is authorized only to the floor(s) identified in the security level
(beep).
1
? ? ? ?
(beep).
? ? ? ?
(beep).
(beep) for multiple systems.
? ? ? ?
(beep).
This phone number
(beep).
27