Sony DSR-2000A Service Manual page 47

Removal/Reattachment of the SE-525 board (LED
holder assembly)
(1) Remove the top panel. (Refer to Section 3-3.)
(2) Remove the cassette compartment.
(Refer to Section 3-4.)
(3) Remove the RMP (T1) holding assembly.
(Refer to Section 7-8.)
(4) Remove the rail assembly. (Refer to Section 7-15.)
(5) Remove the LED holder assembly from the rail
assembly.
(6) Reattach the LED holder assembly to the rail assem-
bly.
(7) Reattach the SE-525 board in the reverse order of the
removing steps (1) to (4).
Tightening Torque : 0.1 N.m {1 kgf.cm}
LED holder assembly
Claw
Rail assembly
SE-525 board
DSR-2000A/2000AP
Removal/Reattachment of the SE-538 board
(1) Remove the SE-521 board. (Refer to this section
Removal/Reattachment of the SE-521board.)
(2) Remove the screw to remove the SE-538 board.
(3) Reattach the SE-538 board in the reverse order of the
removing steps (1) and (2).
Tightening Torque : 0.1 N.m {1 kgf.cm}
Claw
SE-525 board
SE-521 board
P1.4 x 2
Positioning hole
Protrusion
SE-538 board
3-23