Sony DSR-2000A Service Manual page 40

Removal/Reattachment of the EX-752 board
(1) Remove the RP-111 board from the unit. (Refer to this
section Removal/Reattachment of RP-111.)
(2) Remove the RP shield by removing the four screws
(B3 x 6).
(3) Remove the EX-752 board upward.
(4) Fit the notch of the EX-752 board in the slot in the
chassis and reconnect the connector (CN300) of the
EX-752 board to the connector (CN300) of the MB-
859 board.
(5) Fit the two positioning holes of RP shield onto the two
protrusions on the chassis and fix the board with four
screws (B3 x 6).
(6) Reattach the RP-111 board. (Refer to this section
Removal/Reattachment of the RP-111 board.)
Screws
B3 x 6
Positioning
holes
CN300
Protrusions
CN300 (MB-859 board)
3-16
RP shield
Screws
B3 x 6
EX-752 board
Slot
Removal/Reattachment of the HP-99 board
(1) Remove the control panel. (Refer to Section 3-3.)
(2) Lift up the right/left hinge levers in the arrow direction
and bring the control frame assembly to the lateral
position, then loosen the two screws (PWH3 x 6).
(3) Disconnect the flexible card wire form the connector
(CN710) of the KY-452 board.
Control frame assembly
Screw
PWH3 x 6
Flexible card wire
Control frame assembly
Hinge lever
CN710
Screw
PWH3 x 6
DSR-2000A/2000AP