Front Panel Setting - Sony DSR-2000A Service Manual

2-9-2. Front Panel Setting

[Control Panel]
(1) VIDEO INPUT select switch setting : COMPOSITE ; Ordinary video signal
(2) AUDIO INPUT SELECT :
[SUB sidiary Control Panel]
(1) CHARACTER :
(2) CONTROL PANEL :
(3) REC INHIBIT :
(4) KEY INHIBIT :
(5) PROCESS CONTROL :
(6) INT/EXT-PRESET/REGEN :
(7) FREE RUN/REC RUN :
(8) DF/NDF :
(9) VITC :
(10)TC SELECT :
(11)VIDEO :
(12)SET UP :
(13)CHROMA :
(14)Y/C DELAY :
(15)CHROMA PHASE :
(16)SYNC :
(17)SC :
DSR-2000A/2000AP
Y-R, B ; Component signal (Betacam)
S VIDEO ; Y/C separation type S Video signal
SDI ; Component digital signal
SDTI/i.LINK ; DV compressed digital signal
Analog/Digital (AES/EBU)/SDI
Selects either the character information is superimposed in the
video signal output from the SDI OUTPUT 3 (SUPER) and
VIDEO OUT 3 (SUPER) connectors or not.
Selects the status of the control panel when operating this unit.
Inhibits recording on a tape.
Disables operation of the buttons specified on the upper/lower
control panels.
Selects the control method and setting of the built-in digital
video processor.
Selects internal time code/external time code, and preset the
built-in time code generator.
Selects synchronous operation of the built-in time code
generator.
Selects the synchronous operation of the time code generator
and the counter.
Sets ON to record the VITC generates in the built-in time code
generator.
Selects the time code displayed on the time counter display
block.
Adjusts the output level of the video signal.
Adjusts the setup level.
Adjusts the output level of the chroma signal.
Adjusts the amount of the Y/C delay.
Adjusts the chroma phase (the relative phase with the burst
signal).
Adjusts the sync phase of the output signal.
Adjusts the phase of the subcarrier.
2-11