Sony DSR-2000A Service Manual page 38

(5) Remove the fifteen screws (BVTP3 x 10) and eight
screws for connector and detach the CP-341 board by
opening the board in the arrow direction.
n
Use care not to break the terminals of capacitors, etc.
when removing the CP-341 board.
(6) Set the CP-341 board in the reverse direction of the
arrow and fix temporally it to the rear panel with the
fifteen screws.
(7) Apply a half-drop size of screw-locking compound to
each screw for connector, and tighten securely the
eight screws for connector together with the fifteen
screws.
(8) Reconnect the seven connectors disconnected in Step 2
with tweezers, using care to set the right color in the
right place.
(9) Reattach the rear panel to the unit by connecting
securely the five connectors of the CP-341 board
(CN601, CN602, CN603, CN604, and CN605) and the
three connectors of the CP-342 board (CN606, CN607,
and CN608) to the eight connectors of the MB-859
board.
(10)Fix the rear panel with the unit with the five screws.
Screw
BVTP3 x 10
Screws
BVTP3 x 10
Screws for
connector
Screws
CN608
BVTP3 x 10
3-14
CP-341 board
CN605
CN604
CN603
CN602
CN601
CN607
CN606
CP-342 board
Removal/Reattachment of the CP-342 board
(1) Remove the top panel. (Refer to Section 3-3.)
(2) Disconnect the harness from the connector (CN3) on
the CN-1968A board.
(3) Remove the seven connectors (blue, yellow, orange,
green, red, black, and white) on the rear panel with
tweezers.
(4) Remove the five screws (B3 x 6) and remove the rear
panel in the arrow direction
Red
Screws
B3 x 6
Connctor panel
Screws
B3 x 6
White
Black
Green
Orange
Yellow
Blue
Harness
CN3
Connectors
(MB-859 board)
DSR-2000A/2000AP