Sony DSR-2000A Service Manual page 41

(4) Slide the control frame assembly in the arrow direction
to remove it.
(5) Remove the screw and release the two claws form the
rear side of the assembly and remove the KY cover.
(6) Disconnect the harness from the connector (CN2) of
the HP-99 board.
(7) Remove the two nuts to remove the HP-99 board.
n
Support the HP-99 board from the rear side when
removing the nuts.
Nuts
CN2
HP-99 board
Harness
Claw
KY cover
DSR-2000A/2000AP
Control frame assembly
Claw
Screw
PWH3 x 6
(8) Reattach the HP-99 board in the reverse order of the
removing steps (1) to (7).
m
. When reattaching the KY cover, check that the
portion A is inserted to the control frame assembly
correctly.
NG
KY cover
Portion A
Control frame assembly
. When connecting the flexible card wire to the
connector (CN710) on the KY-452 board, attach the
ferrite core as following figure.
Flexible card wire
KY cover
OK
KY cover
Portion A
Control frame assembly
Control frame assembly
Portion A
CN710
Ferrite core
3-17