Sony DSR-2000A Service Manual page 173

Replacement
1. Moving the S/T reel tables
Bring the S/T reel tables to the L cassette position
(the most front side) by turning the reel shift
motor gear in the arrow direction by a finger.
[Reference] [Reference] [Reference] [Reference] [Reference]
This provides easy operation of succeeding tasks.
2. Removing the S tension regulator
assembly
Remove the S tension regulator assembly.
(Refer to Section 7-11.)
3. Removing the T drawer arm assembly
Remove the T drawer arm assembly.
(Refer to Section 7-12.)
4. Removing the RMP retainer (T1)
assembly
Remove the two screws and remove the RMP
retainer (T1) assembly.
5. Removing the head cleaner
Remove the head cleaner. (Refer to Section 7-21.)
6. Removing the rail assembly
(1) Disconnect the flexible card wire from the
connector (CN2) on the SE-522 board.
n
Use extreme care not to fold and not to
scratch the flexible card wire when discon-
necting.
DSR-2000A/2000AP
S reel table
Flexible card wire
Reel shift
motor gear
T reel table
SE-522 board
Connector (CN2)
7-43