Sony DSR-2000A Service Manual page 155

8. Reattaching the RMP (T1) retainer
assembly
(1) Fit the two positioning holes in the RMP (T1)
retainer assembly on the two positioning pins
on the MD chassis.
(2) Tighten the two screws to fix the RMP (T1)
retainer assembly while drawing lightly the T
drawer arm assembly in the arrow direction.
9. Reattaching the MIC assembly
Reattach the MIC assembly.
(Refer to Section 7-19.)
10. Reattaching the L push plate
Reattach the L push plate. (Refer to Section 7-3.)
11. Reconnecting the connector
Reconnect the flexible card wire to the connector
(CN6) on the MS-64 board located on the back
side of the MD chassis.
m
. Be careful not to insert the flexible card wire
obliquely.
. Do insert the flexible card wire straight and
securely as far as it will go.
. Take care not to fold the flexible card wire.
This shortens the life of the flexible card wire.
12. Checking the performance
Check the S/T reel tables move smoothly by
turning the reel shift motor gear by a finger.
13. Reattaching the MD cover
Reattach the MD cover. (Refer to Section 7-2.)
Adjustment after replacement
14. T-REEL ONLY adjustment
(Refer to Section 5-3-3.)
15. TENSION adjustment
(Refer to Section 5-3-3.)
16. Tape path adjustment
(Refer to Section 8-2.)
DSR-2000A/2000AP
Positioning hole
T drawer arm assembly
Positioning pin
P1.4 x 3.5 (a)
RMP retainer (T1) assembly
P1.4 x 3.5 (b)
Positioning hole
7-25