Locations And Functions Of Parts; Front Panel - Sony HSR-X206 Operating Instructions Manual

Locations and Functions of Parts

Front Panel

5 MONITOR 2 button and indicator
4 OSD button and Indicator
3 QUAD button and indicator
2 MULTI button and indicator
1 POWER indicator
POWER
ALARM
ALARM FULL
FULL
qh FULL indicator
qg ALARM FULL indicator
qf ALARM indicator
1 POWER indicator
Lights in green when the power is applied to the unit
and goes dark when the power is disconnected.
It flashes in red if any problem occurs with the hard-
disk drive or fan.
Note
In order to keep the unit internal temperature low, a
fan is provided on the side of the unit. If the fan does
not operate properly, the POWER indicator will flash
to indicate a problem. Unplug the unit from the power
supply and check to make sure nothing is obstructing
the fan. If after the power is restored to the unit, the
POWER indicator still flashes, do not use the unit and
consult your dealer.
2 MULTI (Multi screen) button and indicator
When you press this button, the monitor changes to
6-division screen display.
3 QUAD (4-division screen) button and indicator
When you press this button, the monitor enters 4-
division mode. With each subsequent press of this
button, the next 4 pictures are displayed.
8
6 ALARM RESET button
MULTI QUAD OSD MONITOR 2
ALARM RESET
1 2 3 4 5 6
INPUT SELECTOR
DIGITAL SURVEILLANCE RECORDER HSR-X206
qj INPUT SELECTOR buttons
and indicators
7 LOCK indicator
8 Record/Playback buttons
9 MENU button
q; EXIT button
qa SHUTTLE HOLD button and indicator
qs Shuttle dial
SHUTTLE
-
l ALARM L HOLD
LOCK
PRE REVERSE PLAY
MENU OSD
S PAUSE s STOP G PLAY
ZOOM SEARCH
REC SEQUENCE COPY
a REC
TIMER
STOP
ws Menu reset button
wa COPY button and indicator
w; SEARCH button
ql SEQUENCE button and indicator
qk ZOOM button and indicator
4 OSD button and indicator
Each time you press the button, the position of the on-
screen data will change in sequence of bottom, no
display, and top (default: top).
For details on the on-screen data, see "On-screen Data" on
page 13.
5 MONITOR 2 button and indicator
When you press this button, the indicator lights, and
the unit enters Setup mode for the submonitor
connected to the MONITOR/MON 2 connector.
When you press the button again, Submonitor Setup
mode is released.
6 ALARM RESET button
When you press this button in alarm status, the alarm
indications are all reset.
7 LOCK indicator
Lights in red when the security lock function is active.
When you press an operation button with this indicator
lit, the indicator flashes, and a message is displayed to
prompt you to enter a password.
For details on the security lock and password, see "Security
Lock Settings" on page 63.
qd Jog dial
PUSH
wd CF card slot