Allocate The Remote Controlled Socket A Control Button On The Remote Control; Connecting Devices - Silvercrest 91089 Operation And Safety Notes

Preparation
Allocate the remote
controlled socket a
control button on the
remote control
With the DIP switch
button, A to D, into remote control
Note: E can not be selected with
the DIP switch.
DIP switch
remote controlled socket
A B
ON OFF OFF OFF OFF
A
B OFF ON OFF OFF OFF
OFF OFF ON OFF OFF
C
D OFF OFF OFF ON OFF
Put the cover
11
Put the screws
the screw holes and tighten them.
Example
Put the system code 123 into the remote
control by pushing the DIP switch
1
up to „1", „2" and „3" whist keeping
„4" and „5" in the down position:
View back side of the remote
control
30 GB
put in a control
10
1
C D E
back on.
in the threads of
12
Put the system code 123 in all of the re-
mote controlled sockets
remote controlled socket
control button „A" on the remote con-
trol by pushing the DIP switch „A"
1
up for the remote controlled socket
: whilst keeping the DIP switches B, C,
and D in the down position. This remote
controlled socket
switched on and off with the control
button „A" on the remote control
View back side of the remote
controlled socket

Connecting devices

Plug the remote controlled socket
into an earthed household socket.
To guaranty the protection type IP44,
the remote controlled socket
be plugged exclusively into sockets with
protection type IP44. With use in com-
bination with a IP20 socket there is no
moisture protection guarantee.
The remote controlled socket
only be plugged in the the direction
shown on the device label for the spray
water protection to be guarantied
(arrow must be pointing up).
The range of the remote control's
radio signal reaches max. 25 m and is
dependent on the structural conditions.
The range can be impaired by
. For the first
7
chose the
7
7
can now be
7
.
1
7
should
7
can
7
1