Setting Up The Remote-Controlled Socket - Silvercrest 113854 Operation And Safety Notes

Setting up
pushing away the battery compart-
ment cover
4
two batteries AAA. Make sure you
fit the battery the right way round
(polarity).
2. Press one of the ON / OFF buttons
or to test whether the remote
2 3
control works; if it does, the power
indicator light will come on
S etting up the remote-
Q
controlled socket
1. Plug the remote-controlled socket
into an earthed household socket.
2. The LED operating status display
will now flash slowly for approx.
30 seconds after plugging in.
3. Aim the remote control at the
remote-controlled socket at a
distance of approx. 50 cm.
4. With the LED operating status dis-
play flashing, press the desired
5
ON button of the channel ON /
OFF button
2
the remote control. The LED operat-
ing status display
continuously. You can now use the
remote control to switch a connect-
ed device on or off using.
5. Repeat this process with the other
remote-controlled socket.
6. You can use one channel ON/OFF
button to switch several remote-
2
controlled sockets at once. You can
further train six remote controls suc-
cessively and use these for a single
receiver. This means you can switch
one appliance on and off from up
8 GB
downwards. Insert
.
1
5
(A, B, C or D) on
will now light
5
to six different places.
7. In this case, synchronise every
remote-controlled socket with the
channel of the remote control.
8. The codes for the remote control
will also remain stored when
changing the batteries.
9. The codes will remain permanently
stored when disconnecting the
remote-controlled socket from the
power supply.
10. Avoid interference: Ensure the vari-
ous remote-controlled sockets are
approx. 50 cm apart.
11. The LED operating status display
indicates if the remote-controlled
socket is in ON/OFF mode.
Deleting a code:
To delete a code, first repeat steps
1 – 3.
With the LED operating display
flashing, press the desired OFF
button of the channel ON/ OFF
button (A, B, C or D) you wish
2
to delete on the remote control.
The LED operating status display
will flash rapidly for approx. 2 sec-
onds to confirm deletion.
It will then flash slowly again for
approx. 30 seconds and a new
code entered.
Deleting all codes:
To delete all codes, first repeats
steps 1 – 3.
Then with the LED operating status
display flashing, press the
5
ALL-OFF button
control. The LED operating status
5
5
5
on the remote
3