Battery Installation - Triumph Bonneville T100 Series Owner's Handbook Manual

Maintenance and Adjustment
Do not use an automotive quick
charger as it may overcharge and
damage the battery.
For help with selecting
charger, checking the battery voltage
or battery charging, contact your local
authorised Triumph dealer.
Should the battery voltage fall below
12.7 Volts, the battery should be charged
using a Triumph
charger. Always remove the battery
from the motorcycle and follow the
instructions supplied with the battery
charger.
For extended
(beyond two weeks) the battery should
be removed from the motorcycle and
kept charged using a Triumph approved
maintenance charger.
Similarly, should the battery charge
fall to a level where it will not start the
motorcycle, remove the battery from
the motorcycle before charging.
142
Caution
a battery
approved battery
periods of storage

Battery Installation

Warning
Make sure that the battery terminals
do not touch the motorcycle frame.
This may cause a short circuit or spark
which would ignite battery gases
causing a risk of personal injury.
Bonneville T100 (all models),
Bonneville T120 (all models),
Street Scrambler and Street Twin
To install the battery:
• Place the battery in the battery
case.
• Refit the USB port socket and
secure with the battery strap.
• Reconnect the battery, positive lead
(identified with red tape) first.
• Tighten the battery terminals to
4.5 Nm.
• Apply a light coat of grease to the
terminals to prevent corrosion.
• Cover the positive terminal with the
protective cap.
• Place the ECM unit in its original
position.
• Reconnect the
accessory cables.
• Refit the fixing to secure the ECM
unit.
• Refit the seat (see page 72).
rear light and