Advertisement
15. Connect the flexible non-metallic conduit to the charger power source (e.g. junction box). Do
not cut conduit or input wiring.
16. Connect the wires using UL listed waterproof wire nuts in the following manner (Note that the
supply-side wire may be a different gauge wire):
Input power
Line 1 (HOT)
Line 2 (HOT)
Ground
Neutral
The neutral wire must be connected to the supply-side neutral wire in order for the
charger to function properly.
Warning
17. Reinstall the junction box cover.
System Test (Refer to figures 1 & 2)
18. Turn on the circuit breaker located in the service panel.
19. Perform the Charging Circuit Interrupting Device (CCID) test. Refer to the owner's manual for
test procedure.
20. Remove the coupler paddle from holster. Verify the charger displays
momentarily, then
the circuit breaker or CCID has not tripped. Also check the input voltage and all wiring
connected to the charger.
21. Return the coupler paddle to its holster. Verify that the display goes blank.
22. The charger is now ready for use.
Site Clean Up
23. Recover all packing materials for return to the distributor.
24. Pick up all debris around the work area and sweep clean.
25. Present the owner's manual and installation manual to the owner of the charger.
208 - 240 Vac, Single phase
Black Wire
Black Wire
Green Wire
White Wire
E
. Note that if the display does not illuminate, verify that
F
6
H O U R S T O
C H A R G E
C O M P L E T E
D E L A Y
E
M A IN T A IN
S T A N D B Y
F
Advertisement
