Advertisement
GROUNDING INSTRUCTIONS - This charger must be connected to a permanently grounded
wiring system. An equipment-grounding conductor should be run with circuit conductors and
connected to the equipment-grounding lead on the battery charger. Connections to the battery
anger
charger should comply with all local codes and ordinances.
NOTICE: Do not install the charger in a location that exposes it to extreme heat.
NOTICE: Do not install the charger in a location that blocks the air intake or exhaust vents (bottom
side). Allow 46 cm (18 inches) of clearance directly underneath the unit to allow for
proper cooling.
5HTXLUHG,QVWDOODWLRQ7RROVDQG0DWHULDOV
Tools:
Common Hand Tools
10 - 100 lb-in Torque Wrench (Hex insert)
WM7200 Installation Kit P/N 27005410 (Available to authorized installers only)
Required Installation Material:
Wall Mount Installation:
Wall Mount Kit P/N 09351739
Six #12 x 2 ½ inch wood screws, zinc plated
Four Wire Nuts (8-10 AWG), UL listed waterproof connector
Floor Mount Installation:
Floor Mount Kit P/N 09351749
Replacement Hardware:
Do not replace any of the fasteners (screws) on the charger with alternate parts. Doing
so may result in the loss of the warranty.
Danger
If replacement parts are needed, please contact your Magne Charge™ Sales and Service
Representative for assistance.
,QYHQWRU\
Inductive Charger Model WM7200 SCM Owner's Manual
Inductive Charger Model WM7200 SCM Installation Manual
Warranty / Registration Card
Inductive Charger Model WM7200
2
Advertisement
