Advertisement
:DOO0RXQW,QVWDOODWLRQ
Inspection (Refer to figures 1 & 2)
1. Remove the charger from its shipping container. Note that the shipping container and
packaging material are re-useable. Do not destroy. Save these items, or return them to your
distributor.
2. Make certain the coupler paddle is in its holster.
3. Familiarize yourself with the Magne Charge™ charger.
• Note the location of the two top mounting holes.
• Note the location of the four bottom mounting holes.
• Note the color of the four electrical wires; two black, one green, and one white.
− The two black 10 AWG wires are for input power
− The green 10 AWG wire is for chassis / equipment ground.
− The white 12 AWG wire is for the neutral connection.
Bracket Installation (Refer to figures 1, 3, & 4)
4. Use the bottom mounting bracket to mark the location for the mounting screws. Verify that the
bottom mounting bracket is level and (if required) is at least 46 cm (18 in) above the charging
surface.
5. Drill pilot holes into the center of each stud where the screws will be installed.
6. Fasten the bottom mounting bracket to the wall using four #12 zinc-plated wood screws.
7. Using the #30 tamper-resistant bit and hex driver, remove the two screws on the back of the
charger.
8. Note that there are two different size holes on the top mounting bracket. The side with the
smaller sized holes must be placed against the housing. Align the two center holes on the top
mounting bracket with those on the housing.
9. Using the same two screws, attach the top mounting bracket to the housing.
Charger Installation (Refer to figures 2 & 3)
Turn off the circuit breaker at the service or distribution panel supplying electricity to the
charger and verify that high voltage is not present before performing the following steps.
Danger
10. Lift the charger onto the bottom mounting bracket.
11. Fasten but do not completely tighten the top mounting bracket to the wall using two #12 zinc-
plated wood screws.
12. Align the four holes on the bottom mounting bracket with those on the charger.
13. Fasten the charger to the bottom mounting bracket using four #30 tamper-resistant screws.
Torque to 40 lbs-in.
14. Tighten the two top mounting bracket screws.
5
Advertisement
