Action Commands In Voice Data State - ZyXEL Communications Omni 288S User Manual

<code>
7 (0x37)
8 (0x38)
9 (0x39)
0 (0x30)
A (0x41)
B (0x42)
C (0x43)
D (0x44)
* (0x2A)
# (0x23)
o (0x6F)
c (0x63)
e (0x65)
h (0x68)
H (0x48)
s (0x73)
q (0x71)
$ (0x24)
l (0x6C)
b (0x62)
u (0x75)
a (0x61)

Action Commands in Voice Data State

The DTE may initiate actions by inserting a <DLE> shielded code into the data to
the DCE. The form of the action is <DLE><code>, where <code> is one of the
character values listed in the following table:
<code>
<NUL> (0x0)
<DLE> (0x10)
<SUB> (0x1A)
Chapter 10 - Voice Mode Operation
Event Report Description
DTMF 7
DTMF 8
DTMF 9
DTMF 0
Extended Keypad DTMF A
Extended Keypad DTMF B
Extended Keypad DTMF C
Extended Keypad DTMF D
Extended Keypad DTMF *
Extended Keypad DTMF #
Buffer Overrun.
T.30 fax calling tone (1100Hz). The time interval between
reports is 4.0 seconds.
Data modem calling tone (1300Hz). The time interval between
report is 4.0 seconds.
Line current break (local phone goes on-hook).
Line current detected (local phone goes off-hook).
Silence detected. The DCE has determined that there was no
voice energy present at the beginning of the voice receiving
session followed by a period of silence greater than the amount of
time selected by the +VSD command.
Quiet detected. The DCE has determined that there was voice
energy present at the beginning of the voice receiving session
followed by a period of silence greater than the amount of time
selected by the +VSD command.
Bong Tone (300Hz for 1 second).
Loop current interruption. This may be a remote hang-up.
BUSY. If the DCE continues to detect BUSY , it may report
this event repeatedly. The delay between reports is 4.0 seconds.
Transmission Buffer Underrun. The DCE will report this code if
the DCE's buffer becomes empty without first receiving a
<DLE><ETX> or a <DLE><CAN> command.
Data answer tone. The delay between reports is 4.0 seconds.
Event Report Description
Does nothing. The DTE can use the code to refresh the
DTE/DCE Inactivity Timer, instead of XON.
Two contiguous <DLE><DLE> codes indicate a single <DLE> is
in the data stream.
<DLE><DLE> in the data stream.
10-9