ZyXEL Communications Omni 288S User Manual page 77

Status Report Result Codes
When the Omni 288S is set in the fax mode, each ATD or ATA command will
make the modem try to establish a fax connection. The Omni 288S will send a
status report result code back to the DTE (computer).
NO DIAL TONE
NO CARRIER
BUSY
NO ANSWER
CONNECT FAX
When a fax connection is successfully established, the modem returns this
message:
CONNECT FAX/SnnnnVnTnRnLnCnP<string>
This message includes the connection speed and the fax parameters explained in
the table below.
Field Description
Snnnn
Vn
Tn
Rn
Ln
Cn
P<string>
After each fax disconnection, the following result code is sent back to the DTE:
DISCONNECTnP<string>
This result code informs DTE of the disconnecting status.
Field
DISCONNECT0
DISCONNECT1
P<string>
The basic AT commands ATV0 and ATQ1 do not affect the above CONNECT
and DISCONNECT status report result codes. The modem will always return the
same status format as above.
Chapter 9 - Fax Operation
Tried to dial but no dial tone is detected.
Handshake fails or no carrier is detected or time-out.
Other party's phone line is busy.
Quiet answer is not detected before time-out.
See below.
Fax connection speed; nnnn is a 4-digit number representing
the connection speed. nnnn =1440, 1200, 9600, 7200, etc.,
1440 and 1200 stand for 14400 and 12000.
Vertical resolution; n = 0 or 1.
Coding scheme; n = 0 or 1.
Recording width; n = 0, 1, or 2.
Recording length; n = 0, 1, or 2.
Scan line time; n = 0 to 7.
Remote fax number.
Description
Disconnect with remote confirmation.
Disconnect without remote confirmation.
Remote fax number.
9-15