Extended At* Command Set - ZyXEL Communications Omni 288S User Manual

Extended AT* Command Set

Command Options
*Cn
*C0 *
*C1
*C2
*C3
*Dn n=0-49
*D0 *
*En
*E0 *
*E1
*Fn
*F0
*F1
*Gn
*G0
*G1
*G2
*G3
*G4
*G5
*Hn n=0-39
*HS
*In
*I0
*I1
*I2
*Mn
*M0
*M1
*Pn n=0-15
*P9 *
*Qn
*Q0
*Q1
*Q2 *
*Q3
*Rab
Chapter 11 - AT Command Set Summaries
Function & Description
Character length, including start, stop and parity bit.
10-bit character length.
11-bit character length.
9-bit character length.
8-bit character length.
Set default dial pointer at telephone directory location n. S29
(See also S35.4 and S38.0)
Modem error control negotiation.
if error control negotiation fails, keep the non-error
control connection.
If error control negotiation fails, disconnect the call
(hang-up).
Remote configuration enable
Deny remote configuration
Accept remote configuration (Remote Digital Loop-back
must be granted, &T4)
Security function selection
Disable security function
Enable type 1 security, with password check (ZyXEL to
ZyXEL only)
Enable type 1 security, with password check and call
back (ZyXEL to ZyXEL only)
Enable type 2 security, with password check
Enable type 2 security, with password check and call
back
Enable type 2 security, with password check and call
back, remote user enters the call back number
Modify user password table at location n.
Modify supervisory password (Default: "ZyXEL")
Command set selection
AT command set
V.25bis command set
Dumb mode
Leased line auto-handshake mode selection
Set to Originate mode
Set to Answer mode
Set leased line transmission power level; ranges from 0
dBm to -15 dBm (default: -9 dBm) (see also S35.3)
Action taken when line quality changes.
No action to poor signal quality.
Retrain action taken if signal quality is poor. (See also
S41.2)
Adaptive rate, automatic fall-back or forward.
Disconnect if signal quality is poor.
Read remote profile "b" to local user profile "a"
11-7
Ref.
S15.3-4
S21.0
S36.0
S36.5-7
S17.6-7
S14.0
S17.1-4
S27.6-7
S36.1