ZyXEL Communications Omni 288S User Manual page 100

Command Options Function & Description
M2
M3
N n n=0-7
5 *
O
O1
Q n
Q0 *
Q1
Q2
Sr.b= n
Sr.b?
Sr= n
Sr?
T
UPX
V n
V0
V1 *
X n n=0-7
5 *
Z n n=0-4
Zn
Z4
$
Chapter 11 - AT Command Set Summaries
Speaker always ON
Speaker ON after the last digit is dialed out and OFF
when carrier is detected
Ring volume control.'N0' will disable the audio ring
function
Return to on-line state
Force modem to request a retrain
Result code displayed
Modem returns result code
Modem does not return result code
Modem returns result code but quiet after answering on a
RING (see also S42.2)
Set bit 'b' of S-register 'r' to value 'n'. 'n' is a binary digit
'0' or '1'
Display value of bit 'b' of S-register 'r'
Set S-register 'r' to value 'n'. 'n' must be a decimal
number between 0 and 255
Display value stored in S-register 'r'
Ton dial
Download firmware to the Flash EPROM usin Xmodem
protocol
Sets display type for Result Codes
Display result code in numeric form. (See also S35.7 and
the result code table of 'ATXn')
Display result code in verbose form.
Result code options, see the Options Table
Reset modem and set power-on profile.
Reset modem and load user profile n (0-3).
Reset modem and load factory settings.
Basic command summary help
11-2
Ref.
S24.1-3
S23.7
S40.1
S23.1
S23.6
S23.3-5
S15.5-7