ZyXEL Communications ES-2108 User Manual page 58

ES-2108 Series User's Guide
Table 7 Status: Port Details (continued)
LABEL
PD
Consumption
(W)
LACP
TxPkts
RxPkts
Errors
Tx KB/s
Rx KB/s
Up Time
Tx Packet
The following fields display detailed information about packets transmitted.
TX Packets
Multicast
Broadcast
Pause
Rx Packet
The following fields display detailed information about packets received.
RX Packets
Multicast
Broadcast
Pause
TX Collision
Single
Multiple
Excessive
Late
Error Packet
RX CRC
Runt
Distribution
64
58
DESCRIPTION
This field is only available on the ES-2108PWR but not available for the Gigabit and
mini-GBIC ports.
This field shows the power consumption of the powered device connected to the port.
This field shows if LACP is enabled on this port or not.
This field shows the number of transmitted frames on this port
This field shows the number of received frames on this port
This field shows the number of received errors on this port.
This field shows the number kilobytes per second transmitted on this port.
This field shows the number of kilobytes per second received on this port.
This field shows the total amount of time the connection has been up.
This field shows the number of good packets (unicast, multicast and broadcast)
transmitted.
This field shows the number of good multicast packets transmitted.
This field shows the number of good broadcast packets transmitted.
This field shows the number of 802.3x Pause packets transmitted.
This field shows the number of good packets (unicast, multicast and broadcast)
received.
This field shows the number of good multicast packets received.
This field shows the number of good broadcast packets received.
This field shows the number of 802.3x Pause packets received.
The following fields display information on collisions while transmitting.
This is a count of successfully transmitted packets for which transmission is inhibited
by exactly one collision.
This is a count of successfully transmitted packets for which transmission was inhibited
by more than one collision.
This is a count of packets for which transmission failed due to excessive collisions.
Excessive collision is defined as the number of maximum collisions before the
retransmission count is reset.
This is the number of times a late collision is detected, that is, after 512 bits of the
packets have already been transmitted.
This field shows the number of packets received with CRC (Cyclic Redundant Check)
error(s).
This field shows the number of packets received that were too short (shorter than 64
octets), including the ones with CRC errors.
This field shows the number of packets (including bad packets) received that were 64
octets in length.
Chapter 6 System Status and Port Statistics