Pairing - Plantronics Discovery 650 User Manual

PAIRING

1.
EN PAIRING
Congratulations—the headset you've purchased now
comes with QuickPair technology,so pairing with your
Bluetooth phone is even easier! Before using your headset
for the first time, you must pair it with your Bluetooth phone
or device. Be sure the headset is fully charged. For set up
and pairing instructions with Bluetooth devices other than
mobile phones, please consult your Bluetooth device user
guide.
1. Begin with headset turned off. Turn headset on (hold
call control button for at least four seconds) and it will
automatically go into pairing mode, flashing red and
blue.
2. While the headset is flashing, use the phone menu to
search for Bluetooth devices and select "6XXPlantronics".
3. When prompted for a passkey, enter 0000. Headset will
flash blue when paired successfully.
4. To pair a second time, press and hold the call control
button for 10 seconds until the headset flashes red then
blue. The headset is now in pairing mode for the next
120 seconds.
TO DISABLE ONLINE AND STANDBY INDICATOR
LIGHTS
When purchased the headset will have the online
and standby indicator lights enabled. To disable these
indicators, press the volume up button while turning the
headset ON. To re-enable both indicator lights, turn the
headset off; then press the volume up button again while
turning the headset ON.
NOTE: This process only disables online and standby
indicator lights when headset is connected to mobile
phone. All other indicator lights, such as low battery, will
continue to function.
16
2.
3.
.٢
.٣