Advertisement
Quick Links
'
(
"
"
(lower position). This will help
distinguish the cables when it comes
time to connect the new extruder.
1 screw on each side.
Then, remove the two screws on the back side of the extruder. They are located undeneath
the two motors.
/
)
(
)
|
Utilities
Move Axes
10.0mm
1.0mm
Move Steps
0.0
0.0
0.0
Filament Loader
L-Nozzle
215 C
Load
Temperature
215 C
R-Nozzle
Load
Home
Tune
Utilities
|
0.1mm
0.0
Unload
Unload
Unload
2.5mm hex
Advertisement
Related Manuals for RAISE 3D Bondtech Dual Extruder
Summary of Contents for RAISE 3D Bondtech Dual Extruder
- Page 1 Utilities Move Axes 10.0mm 1.0mm 0.1mm Move Steps " ” Unload Filament Loader L-Nozzle 215 C Load Unload Temperature 215 C R-Nozzle Load Unload Home Tune Utilities (lower position). This will help distinguish the cables when it comes time to connect the new extruder. 2.5mm hex 1 screw on each side. Then, remove the two screws on the back side of the extruder. They are located undeneath the two motors. ...
- Page 2 (Cont.)
- Page 6 port on the front extruder. ...
- Page 7 The following section will show how the E-Step value can be adjusted directly on the printer. The E-Step value tells the controller the number of steps (micro steps) that are needed to extrude 1mm of lament. The new extruder has a di erent drive gear diameter and gearing ratio and must be adjusted to extrude the proper amount of material.
- Page 8 The installation of the new extruder also requires that the stepper driver is adjusted. The current motors are smaller and require lower current than the original motors. Without this adjustment, there is a risk that the motors can overheat and become damaged. To complete this adjustment, you will need: -A Multimeter -A Hex Wrench or Flathead Screwdriver...
- Page 9 ) . Clockwise will increase the number and counterclockwise will decrease it.