Related Manuals for RAISE 3D Pro2 Series-105 XY
Summary of Contents for RAISE 3D Pro2 Series-105 XY
- Page 1 Version 1.0 Date：29/08/2018 Manual Pro2 Series-105 XY Gantry Adjust-v1.0 Preparation: 1. Unload filament. 2. Move the build plate to center height. 3. Turn off the power. Tools： leveling cube. 2mm hex wrench. 2.5mm hex wrench. - 1-...
- Page 2 Version 1.0 Date：29/08/2018 Step 1: Use a 2mm hex wrench to loosen all 16 screws on x/y gantry. Step 2: Use 2.5mm hex wrench to loosen all 8 M3x8 screws on x/y gantry block. - 2- www.raise3d.com...
- Page 3 Version 1.0 Date：29/08/2018 Screws Step 3: Place the leveling block on the left side of X axis. Push the extruder head to the left side against the leveling block. Step 4: Use a 2mm hex wrench to tighten all 8 screws shown in the picture, which secure the rods on the lower position.
- Page 4 Version 1.0 Date：29/08/2018 Step 5: Take the leveling block out and place it on Y axis. Push the extruder head against it tightly. Step 6: Use a 2mm hex wrench to tighten all 8 screws shown in the picture, which secure those rods on the higher position.
- Page 5 Version 1.0 Date：29/08/2018 Step 7: Push the extruder head to the original position and apply lubrication to all rods. Move the head around to check its motion. - 5- www.raise3d.com...
- Page 6 Version 1.0 Date：29/08/2018 Step 8: Place the extruder head in the center left position and move it along X direction. If movement happens smoothly, use a 2.5mm hex wrench to tighten the 4 screws for X direction block on the left side. Next move it along the X direction and then if still move smoothly, use a 2.5mm hex wrench to tighten the 4 screws for X direction on the right side.
- Page 7 Version 1.0 Date：29/08/2018 Screws - 7- www.raise3d.com...
- Page 8 Version 1.0 Date：29/08/2018 Screws Step 9: Move the extruder head along the bed to check if moving freely. If not, please re- adjust using the same procedures listed in this document. -END- - 8- www.raise3d.com...