Removing Sump And Motor Assembly - Gws Model - Whirlpool M-17 Technical Manual

Removing Sump and Motor Assembly - GWS Model

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
1. Unplug dishwasher or disconnect power.
2. Complete the steps 1-4
section.
3. Complete the steps 1-7
and Manifold Assembly" section.
4. Remove four TORX T15 screws to sump.
5. Disconnect water supply under sink if necessary.
6. Disconnect drain hose under sink if necessary.
7. Disconnect electrical under sink or at junction box if needed.
8. Pull dishwasher out from under the counter and lay it on it's
back.
from "Drip Pan and Float Assembly"
from "Removing Lower Spray Arm
Whirlpool and KitchenAid
®
9. Cut the hose clamp crimp to remove the hose to the sump.
NOTE: For reconnecting the hoses, re-crimp a new
replacement clamp in the positions shown in the figure.
10. Press in both sides of the TPA to remove the connector from
the housing. Pull the TPA out of secured position and remove.
Motor Assembly GWS Model
11. Push to release the tab and pull up the connector to remove
from the housing.
Filtration and Maytag
® ®
COMPONENT ACCESS (Cont.)
24" Microfiltration Dishwashers 4-21
n