Drip Pan And Float Assembly; Removing Sump And Motor Assembly - Whirlpool M-17 Technical Manual

Drip Pan and Float Assembly

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
Remove Drip Pan and Float Assembly
1. Remove toe/access panel using a 5/16" nut driver.
2. To remove the drip pan assembly, press the snap at each side
of the plastic tray in toward the center of the product and
pull toward yourself.
NOTE: Take caution not to pull too far or too hard as the float
switch wire is still connected at this time.
Whirlpool and KitchenAid
®
Remove Float Switch Wire
3. To remove the float switch wire, gently depress the connector
latch tab and then pull the connector out of the housing. To
remove the float push in on the two tabs and lift up on the
float.
Removing Sump and Motor
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
1. Unplug dishwasher or disconnect power.
2. Complete the steps
section.
3. Complete the steps
and Manifold Assembly" section.
4. Remove four (4) TORX T15 screws to sump.
Filtration and Maytag
® ®
COMPONENT ACCESS (Cont.)
Assembly
WARNING
from "Drip Pan and Float Assembly"
1-4
1-7 from "Removing Lower Spray Arm
24" Microfiltration Dishwashers 4-17
n