Product Overview; Controls - Toro Pro Force 44553 Operator's Manual

Product Overview

Controls

Engine Stop
Press the E S button to stop the engine
NGINE TOP
1. LED light
2. Rotate left
3. Decrease engine speed
4. Engine start
Engine Start
After completing the starting sequence, press the E
S button to start the engine
TART
the Engine (page 14) for the starting sequence.
Nozzle Direction
Press the right or left button to rotate the nozzle to the
desired direction (Figure 9).
Engine Speed
Press the I E
NCREASE NGINE
E S (turtle) button to increase or decrease the
NGINE PEED
speed of the engine (Figure
E S and D
NGINE PEED ECREASE
the same time returns the engine to idle.
Ignition Switch
The ignition switch (Figure
stop the engine, has three positions: O
Rotate the key clockwise to S
motor. Release the key when the engine starts. The key moves
automatically to the R
UN
rotate the key counterclockwise to the O
(Figure
Figure 9
5. Rotate right
6. Increase engine speed
7. Engine stop
(Figure 9). Refer to
S (rabbit) or D
PEED ECREASE
9). Pressing the I
NCREASE
E S buttons at
NGINE PEED
10), which is used to start and
, R and S
FF UN
to engage the starter
TART
position. To shut the engine off,
position.
FF
Choke Control
To start a cold engine, move the choke control lever
10) to the O
9).
1. Choke control
2. Hour meter
Hour Meter
The hour meter
machine operation.
Diagnostic Light
NGINE
The diagnostic light
Starting
meter and indicates machine fault codes. After you turn the
key to the R
for 5 seconds, turn off for 5 seconds, and then begin flashing
3 times a second until you push a button on the handheld
remote. If the light turns on for 5 seconds and then starts
blinking 10 times a second (with or without a 5 second pause)
there is a fault with the machine; refer to
Codes (page
Note: If you have a button depressed on the handheld
remote when you start the machine, the light will not flash 3
times a second after it turns off for 5 seconds.
.
TART
1. Diagnostic light
11
position.
N
Figure 10
3. Ignition switch
(Figure 10) indicates the total hours of
(Figure 11) is located below the hour
position, the diagnostic light will illuminate
UN
29).
Figure 11
(Figure
Checking Fault