Servicing The Carbon Canister; Servicing The Engine Oil - Toro Pro Force 44553 Operator's Manual

Servicing the Carbon Canister

Replacing the Carbon Canister Air Filter
Service Interval: Every 200 hours
1. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
2. Remove and discard the carbon canister air filter, but
retain the hoses (Figure
1. Carbon canister
3. Install the new air filter and the previously removed
hoses.
Replacing the Carbon Canister
Purge-line Filter
Service Interval: Every 200 hours
Note: Check the purge-line filter occasionally for dirt. If the
filter appears to be dirty, replace it.
1. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
2. Move the spring-type hose clamps on both sides of the
carbon canister purge-line filter away from the filter
(Figure 21).
20).
Figure 20
2. Carbon canister air filter
2
1
g018506
1. Carbon-canister
purge-line filter
3. Remove and discard the carbon filter
4. Install a new filter into the hose with the arrow on the
filter pointing toward the check valve and secure it with
the hose clamps

Servicing the Engine Oil

Note: Change the oil more frequently when the operating
conditions are extremely dusty or sandy.
Oil Type: Detergent oil (API service SG, SH, SJ or higher)
Crankcase Capacity: w/filter, 2 Liters (67 oz)
Viscosity: See the table below.
21
Figure 21
2. Check valve
(Figure
(Figure 21).
Figure 22
21).