Menu Structure - Multiplex POWER PEAK E7 Operation Instructions Manual

6. MENU StrUCtUrE

(01) Memory name. .
LiPo 7.4 V 2000 mAh
Chg Current
dChg Current
dChg Volt
TVC Volt
StOP / ESC
(Data View)
Main : 11.39 V
Max : 3.81 V
Min : 3.79 V
3.79 V 3.79 V 3.81 V
0.00 V 0.00 V 0.00 V
0.00 V
StOP / ESC
(user setup)
Language : English
Rest Time : 2 min
Safety Cut : OFF
Safety Time : 1 min
Capa Ct : OFF
Capa value : 100 mAh
Key Beep : ON
StOP / ESC
Cycle data
No. Capacity
1 C: 0 mAh
D: 0 mAh
2 C: 0 mAh
D: 0 mAh
3 C: 0 mAh
D: 0 mAh
StOP / ESC
BID EDIT (01/01/2000)
LiPo 7.4 V 2000 mAh
Chg Current
dChg Current
dChg Volt
TVC Volt
Save to BID
Operating Instructions
Power Peak E7 EQ-BID
®
The parameters for charging and discharging batteries are defined In
the "MEMORY NAME" menu. The corresponding settings are stored in
the previously selected memory (see chapter 7).
: 2.0 A
: 1.0 A
: 3.2 V/C
: 4.20 V
The "Data display" menu displays some items of data before and
during the charge / discharge process of a Lithium battery (see chapter
8). This screen display also shows information relating to the equalizing
process of a Lithium battery.
Note:
Only values for LiXX batteries are displayed.
Basic global characteristics are set in the "User settings" menu (see
chapter 9).
The "Cycle data" display (chapter 10) shows the charged-in and
discharged capacity, as well as the maximum battery voltage reached
Voltage
during charging, and the average battery voltage during discharging
11.358 V
of all completed cycles. Data for up to ten cycles can be viewed; the
0.000 V
cycle is selected using the "+" or "-" buttons. Recorded data can only
11.412 V
be viewed at the end of a cycle. To erase the data, either switch the
0.000 V
charger off or connect a new battery.
0.000 V
C: = Charge
0.000 V
D: = Discharge
Note:
If a BID chip of key is connected, the "Cycle data" menu is not dis-
played; instead the screen shows the "BID INFO" menu.
If a battery with the BID system is connected to OUT, the data
stored on the chip are displayed on-screen. The data stored on
: 2.0 A
the BID chip or key can be called up by pressing the "+" or "-"
: 1.0 A
buttons.
: 3.2 V/C
: 4.20 V
21
7
# 30 8127