Zephyr Venezia ZVE-E30S Use, Care And Installation Manual page 12

1. Blower On/Off
By pressing , the blower is switched On and Off. When switched on, the blower starts up on speed level 3.
2. Speed Selection
The 6 speed levels are selected by presing
level selected.
3. Delay Off
This is used for programmed shut down of blower and lights 15 minutes after the function is activated. Press
a dot flashes in the lower right hand side of display
in 15 minutes.
4. Lights On/Off/Dim
Switch lights On and Off by pressing key
5. Advance Display Functions
Filters Clean Reminder (Metal):
After every 30 hours of use, the display will start flashing an
possible clogs.
The standard Metal Filters are required to be cleaned frequently and as recommended in order to maintain blower
efficiency. If improperly maintained, residue from cooking will sift though filters and cause damage to hood blowers
and other sensitive components; and possibly clog duct work and create a fire hazard.
Filters Change Reminder (Charcoal, if fitted):
When your hood is installed as "Recirculating" (Ductless) unit, it is fitted with a set of Chacoal Filters to purify any
exhaust and fumes from cooking, and re-circulates the air within the home. These Charcoal Filters are required to be replaced
after every 120 hours of use. The Filter Change Reminder
microprocessor in the controls when set, will elapsed and count usage time and indicate when charcoal filter replacement is
needed every 120 hrs.
to decrease and to increase speed level. The display indicates
indicating the function is on. The hood will completely shut down
once. To dim lights, press and hold
reminding you to clean the metal filters from residue and
function in the microprocessor needs to be switched on. The
10
www.zephyronline.com
once,
for 2 seconds.