Rohs (Restriction Of Hazardous Substances); Manufacturer's Warranty - Hilti TE 50-AVR Manual

9.1 Troubleshooting
Trouble or fault
The power tool doesn't start.
No hammering action.
The combihammer doesn't
achieve full power.
The drill bit doesn't rotate.
The drill bit can't be released.
The service indicator lights
after changing the carbon
brushes.
10 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Disposal of electric tools or appliances together with household waste is not permissible.
11

RoHS (Restriction of Hazardous Substances)

Click on the link to go to the table of hazardous substances: qr.hilti.com/r4902202.
There is a link to the RoHS table, in the form of a QR code, at the end of this document.
12

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
2102965
*2102965*
Printed: 22.02.2018 | Doc-Nr: PUB / 5283607 / 000 / 04
Possible cause
Interruption in the electric supply.
The electronic restart interlock is
activated after an interruption in
the electric supply.
The power tool is too cold.
The gauge (cross section) of the
extension cord conductors is inad-
equate.
The voltage provided by the elec-
tric supply is too low.
The function selector switch is not
engaged or is in the "Chiseling"
or "Chisel adjustment" position.
The chuck is not pulled back fully.
The side handle is not fitted cor-
rectly.
The contact surfaces are not yet
run in.
Action to be taken
▶ Plug in another electric tool or
appliance and check whether it
works.
▶ Switch the power tool off and
then on again.
▶ Bring the tip of the drill bit
into contact with the working
surface, switch the rotary
hammer on and allow it to
run. If necessary, repeat the
procedure until the hammering
mechanism begins to operate.
▶ Use an extension cord with
an adequate conductor cross
section.
▶ Connect the combihammer to a
different electric supply.
▶ Set the function selector switch
to the "Hammer drilling" position
.
▶ Pull the chuck back as far
as it will go and remove the
accessory tool.
▶ Release the side handle and refit
it correctly so that the clamping
band and side handle engage in
the recess.
▶ Run in the carbon brushes by
allowing the power tool to run
under no load for at least 1
minute without interruption.
English 19